JSCE Guidlines for Concrete No.10
Example of Design Calculations Based on JSCE Standard Specifications for Concrete Structures
-Reinforced Concrete Superstructure of Open-Type Wharf-
CONTENTS
1. Introduction
2. Structure of Open-Type Wharf and Performance Requirements
2.1 Specifications of Structure
2.2 Performance Requirements
3. Conditions for Performance Verification
3.1 Design Service Life
3.3 Load
3.4 Load Combination and Load Factor
3.5 Flow of Performance Verification
3.6 Limit on Crack Width
3.7 Prerequisite of Verification
3.8 Structure Factor
4. Verification of Floor Slab
4.1 Structural Overview
4.2 Performance Verified
4.3 Load Acting on Floor Slab
4.4 Characteristic Values of Force Resultant
4.5 Design Values of Force Resultant
4.6 Examination of Ultimate Limit State
4.7 Examination of Serviceability
4.8 Examination of Fatigue Limit State
5. Verification of Beam
5.1 Structural Overview
5.2 Performance Verified
5.3 Load Acting on Beam
5.4 Characteristic Values of Force Resultant
5.5 Design Values of Force Resultant
5.6 Examination of Ultimate Limit State
5.7 Examination of Serviceability Limit State
5.8 Examination of Fatigue Limit State
6. Examination at Pile-to-Beam Joint
6.1 Introduction
6.2 Examination at Pile Head
6.3 Anchorage of Reinforcement
7. Verification for Durability
7.1 Carbonation-Induced Corrosion
7.2 Chloride-Induced Corrosion
7.3 Freezing and Thawing
7.4 Chemical Attack
7.5 Alkali-Aggregate Reaction
7.6 Water Tightness
8. Constructibility
8.1 Construction Planning
8.2 Performance of Concrete for Construction
8.3 Concrete Production
8.4 Ready-Mixed Concrete
8.5 Mix Design of Concrete
8.6 Verification of Cracking at Construction Stage
9. Maintenance and Rehabilitation
9.1 Maintenance Planning
9.2 Maintenance Category A
9.3 Maintenance Category B
9.4 Estimation of Life-Cycle Cost
9.5 Inspection Plan
9.6 Evaluation of Inspection Result and Selection of Measure
9.7 Record